noise immunity การใช้

• In other words, differential signalling doubles the noise immunity.
• The resulting Schmitt trigger circuit gives additional noise immunity and a cleaner output signal.
• Binary encoding has a notable advantage over all other systems : greater noise immunity.
• Improved noise immunity can be achieved by execution flow control known as token passing.
• However, the digital circuit will calculate more repeatably, because of its high noise immunity.
• Frequency modulation ( FM ) has numerous advantages over AM such as better fidelity and noise immunity.
• The major advantage of encoders with built-in interpolation and digital signal transmission is improved noise immunity.
• TSK is a physical layer advancement that significantly improves bandwidth efficiency, noise immunity, and power consumption.
• In logic circuits, it decreases the noise immunity; in power applications, it increases the dissipated power.
• The specific voltages are different for different logic families and variations are permitted to allow for component aging and noise immunity.
• These loops have the advantages of simplicity and noise immunity, and have a large international user and equipment supplier base.
• Schemes that have desirable noise immunity characteristics for a minimal impact in area is the topic of current research ( Kenner, p . 37 ).
• The NATO competition concluded that MELPe substantially improved performance ( in terms of speech quality, intelligibility, and noise immunity ), while reducing throughput requirements.
• The relatively high impedance and low noise immunity requires a common ground potential, which again restricts practical use to communication within the same PC board or small system of boards.
• For example, in electrical engineering, negative feedback is used in amplifiers to trade stability of the gain and / or bias point, noise immunity, and reduction of nonlinear distortion.
• The combined benefits of twisting, balanced signalling, and quadrupole pattern give outstanding noise immunity, especially advantageous for low signal level applications such as microphone cables, even when installed very close to a power cable.
• Noise immunity on ISO 11898-2 : 2003 is achieved by maintaining the differential impedance of the bus at a low level with low-value resistors ( 120 ohms ) at each end of the bus.
• TTL outputs are typically restricted to narrower limits of between 0.0 V and 0.4 V for a " low " and between 2.4 V and V CC for a " high ", providing at least 0.4 V of noise immunity.
• In such cases, the DI box is placed close to the source device ( such as the guitar and mic ), and any long cables are attached to the output of the DI box ( which usually also converts unbalanced signals to balanced signals to further increase noise immunity ).
• The symbol rate is identical to that of 100BASE-TX ( 125 megabaud ) and the noise immunity of the five-level signaling is also identical to that of the three-level signaling in 100BASE-TX, since 1000BASE-T uses four-dimensional dB coding gain across the four pairs.